Instruction book Audi A3 Version Year 2017
Engine Oil 1L Longlife - Audi Fleecejacke - Audi Mug Audi Beanie - Audi all-weather floor mats Genuine Audi Interior Cargo Organizer
Audi A3 Setting off e-tron Charging the vehicle with the Au...
Applies to: vehicles with plug-in hybrid drive
You can check the operating status by looking at the LED -A-, the display on the operating unit -B- Fig.  and the status LED -2- Fig. .
Symbol
Fault code
LED on operating unit -A-
Meaning
Remedy
 
blue
flashing
Self-test
 
 
green
lit
Cable connected correctly
 
 
flashing
Cable connected and charging
 
 
white
lit
Self-test successfully completed; cable not connected or incorrectly connected to vehicle charging connection.
Connect the cable correctly.
330, 340
red
lit
Cable not connected correctly or defective.
Check the cable and reconnect it or replace the cable.
200, 210, 260, 410, 450, 460, 490, 500
red
lit
Fault in the operating unit.
Disconnect the operating unit from the mains and have the fault rectified by a qualified workshop.
180, 190
red
lit
Operating unit overheated or too cold
Allow the operating unit to cool down or use it within the specified temperature range.
130, 140, 470
red
lit
Communication fault with vehicle.
Have the fault rectified by a qualified workshop.
300, 310, 370, 390
red
lit
Fault in domestic installation.
Have the electrical installation checked by a qualified electrician.
480
red
flashing
Fault in domestic installation (protective earth conductor interrupted).
Have the electrical supply to the operating unit checked by a qualified electrician.
110
red
flashing
Residual current circuit breaker (RCCB) in operating unit tripped.
Reset the RCCB with the OK button -D- Fig. . Have the electrical installation checked by a qualified electrician if the fault is indicated again.

Table Charging system: Operating unit

LED on the vehicle -2-
Meaning
Remedy
green
lit
High-voltage battery charge cycle finished.
Unplug the charging connector, fit the cap and close the cover on the charging unit.
lit (pulsating)
High-voltage battery is charging or air conditioning is on.
 
flashing (for approx. one minute after leaving the vehicle)
Charging timer has been programmed but charging cycle has not yet started. The LED in the button -1- Fig.  will light up in addition.
 
yellow
lit
Charging cable connected but no mains power detected.
Have the power supply or mains checked. Check the status indicators on the operating unit link. Obtain professional assistance if necessary.
flashing
Selector lever is not in position P.
Move the selector lever to position P.
red
lit
Charging connector not properly locked in vehicle charging connection.
Check that the charging connector is plugged in correctly link. Unplug the charging connector and plug it into the charging connection again. Obtain professional assistance if necessary.
flashing
Charging system fault. High-voltage battery cannot be charged.
Or: The outside temperature is too low. The high-voltage battery could not be charged sufficiently.
Obtain professional assistance if necessary.

Table Vehicle: Charging unit

Note
The operating status of the LED -2- on the vehicle is also shown in the instrument cluster/infotainment display.
Engine Oil 1L Longlife - Audi Fleecejacke - Audi Mug Audi Beanie - Audi all-weather floor mats Genuine Audi Interior Cargo Organizer

All images, logos and text are property of © Audi. This site has no relationship with the company Volkswagen - Audi Spain nor any of its affiliates worldwide. For more information. To contact the author of this website click here.