-
- Fig. 1 Bulb housing: Fitting the bulb
-
- Fig. 2 Bulb housing: Fitting the bulb
-
- Fig. 3 Headlight: Cover for dipped headlight
Applies to vehicles: with halogen headlights
If necessary, use a clean cloth to remove any fingerprints from the glass part of the bulb.
Fit the new bulb in the bulb housing. Press the bulb first upwards -A- Fig. 1, then downwards -B- into the bulb holder so that it engages WARNING!.
Turn the connector Fig. 2 clockwise as far as it will go.
Look through the headlight lens to check that the bulb is straight.
Plug the plastic connector back in.
Fit the cover on again and tighten the bolts Fig. 3.
Re-install the headlight Link.
Caution!
Make sure that the cover is correctly seated to ensure that water cannot enter the headlight housing and to prevent the headlight from malfunctioning.