- Fig. 1 Bulb housing: Removing bulb for dipped beam headlight
- Fig. 2 Bulb with connector - guide lug is highlighted
- Fig. 3 Headlight: Cover for dipped headlight
Applies to vehicles: with halogen headlights
Installing
Plug the plastic connector back in Fig. 2.
If necessary, use a clean cloth to remove any fingerprints from the glass part of the bulb.
Press the bulb first upwards, then downwards into the bulb holder so that it engages and is flush with the bulb holder.
Look through the headlight lens to check that the bulb is straight.
Fit the cover on again and tighten the bolts Fig. 3.
Re-install the headlight Link.
Caution!
Make sure that the cover is correctly seated to ensure that water cannot enter the headlight housing and to prevent the headlight from malfunctioning.