|
- Fig. 1 Right side of the rear bumper: Cover cap
- Fig. 2 Right side of the rear bumper: Towline anchorage screwed in
A screw connection is located under a cover on the right side of the rear bumper.
Take the towline anchorage out of the vehicle tool kit
►Link.
To remove the cover cap from the bumper, press it in at the bottom -arrow- and pull it out at the top Fig. 1.
Screw the towline anchorage into the screw connection as far as it will go Fig. 2 and tighten it with the box spanner.
Put the towline anchorage back in the tool kit after use.
WARNING!
If the towline anchorage is not screwed in as far as the stop, there is a risk of the screw connection shearing off during towing - risk of accident!
Caution!
To avoid damaging the towing bracket*, only use tow-bars with suitable attachments. If a tow-bar is not available, a tow-rope may be used.