|
- Fig. 1 Engine compartment: Terminals for jump leads and battery charger
Applies to vehicles: with 5-cylinder engine
Terminals for charging the battery are fitted in the engine compartment.
Switch off all electrical equipment. Remove the ignition key.
Open the bonnet
►Link.
Open the red cap on the positive terminal Fig. 1.
Follow the correct procedure for connecting the charger cables to the jump-start terminals (terminal with cap = "positive", terminal on body = "negative").
Now connect the battery charger to the mains and switch on.
After charging the battery: switch off the battery charger and disconnect the mains cable.
Now disconnect the charger cables.
Close the cap on the positive terminal.
Close the bonnet
►Link.
When it is discharged the battery can freeze at temperatures around 0°C. You must not use a battery which has frozen, even after it has thawed, because the ice may have cracked the battery casing and allowed the battery acid to escape WARNING!.
Charging the battery
Only use battery chargers with a maximum charge voltage of 14.8 V (the battery cables do not have to be disconnected). The battery must not be opened while you are charging it.
Important: Before you charge the battery make sure you read the manufacturer's instructions for using the battery charger.
Note
Use only the terminals in the engine compartment to charge the battery.