Your caller cannot hear your private conversations when the mute function is on. However you can still hear the caller.

First select Hold to place the active call on hold. Then enter the telephone number. Select Dial to dial the number.

Press the control button (soft key) for End call or press the End call button (hard key) once to end whichever call is active. If you placed a call on hold earlier on, that call will remain on hold. You can end the call on hold by pressing the control button (soft key) for End call or the End call button (hard key) again.

The Hold and Resume options allow you to hold a call and retrieve it later from the hold queue.

You can access the menus while a call is active.

The call active at the time is disconnected.

You can switch between two phone calls (one of them will be on hold at any given time).

Press the control button for End call to end whichever call is currently active. The call on hold will remain in the hold queue.

Up to five callers can take part in a conference (depending on the network service).

Select Conference to set up a conference. The call on hold and the active call are added to the conference.

You can make a further call after placing all of the conference callers on hold with the Hold option. To add another caller to an existing conference, select Conference.

Select Resume conference if you want to retrieve all callers of an existing conference from the hold queue. You can use the Conf. participants option to select conference callers individually and remove them from the conference.

This function is used to load DTMF tones from the stored phone numbers. You can also enter DTMF tones directly on the keypad during a call.