You can change the language of the display along with the language of the navigation cues^* and the speech dialogue system^*.

The number of languages available depends on the market.

Where available, the following measurement units can be set: Speed, Distance, Temperature, Consumption, Capacity and Pressure.

Important: Your mobile phone must be Qi compatible1), or it must be connected to the Audi music interface -1- fig.► using a USB adapter cable.

When the reminder signal function is switched on, you will be notified that your mobile phone is still in the Audi phone box^* when you are leaving the vehicle. You can choose between spoken, sound and off.

Reminder signal volume: You can adjust the volume of the reminder signal by turning the rotary pushbutton.

Switch off pop-up: When this function is switched on , the messages about the charging status of the mobile phone in the Audi phone box^* will not appear on the infotainment display. The reminder not to forget the mobile phone when leaving the vehicle will also be switched off.

Your MMI displays usage tips when this function is switched on . They will appear less often as time goes by.

The following functions may be available depending on the equipment installed in your vehicle:

Command display: The MMI displays possible voice commands in the corresponding menu when this function is switched on .

Short dialogue: When this function is switched on , the spoken cues are shortened.

Command during speech dialogue^*: This option is activated when the vehicle leaves the factory. When this option is activated , you can say a new command while the system is giving a spoken cue, rather than waiting for the beep. When this option is deactivated , wait until you hear the beep to say a command.

Volume: You can adjust the volume of the spoken cues by turning the rotary pushbutton.

Individual speech training (only possible when the vehicle is stationary): You can use the individual speech training to adapt the speech dialogue system to your voice or pronunciation so that the speech dialogue system can then better recognise what you are saying. The individual speech training prompts you to repeat 20 spoken phrases that consist of certain commands and blocks of digits. If you would like to delete the stored speech training setup, you can use the function Reset individual speech training.

You can adjust the brightness of the infotainment display by turning the rotary pushbutton.

The following functions can be reset to the factory settings, depending on the vehicle’s equipment:

You can select the desired options individually or mark Select all entries. Select and confirm Restore factory settings.