- Fig. 1 Trim panel: Attachment points are marked by arrows
- Fig. 2 Headlight unit: Attachment points are marked by arrows
Applies to vehicles: with halogen/xenon headlights
Pulling forward
Switch off the ignition and the lights.
Open the bonnet.
Take the screwdriver and the interchangeable Torx bit* out of the vehicle tool kit Link.
To release the retaining clips -arrows- Fig. 1 on the trim panel, press on the centre of the clips with a suitable tool (e.g. the interchangeable Torx bit*). The clips will be released and can then be removed.
Carefully unhook the trim panel at the radiator grille and remove the panel.
Loosen the bottom bolt securing the headlight -A- Fig. 2.
Remove both top bolts securing the headlight -B-.
Carefully slide the headlight forward about 50 mm.
Installing
Perform all of the above steps in reverse sequence.
Caution!
Please take particular care not to damage or scratch the adjacent parts of the body when releasing or installing the headlights.