- Fig. 1 Engine compartment: Terminals for jump leads and battery charger
Terminals for charging the battery are fitted in the engine compartment.
Hybrid vehicles*: If the high-voltage battery is discharged, please refer to the important information on Link.
Switch off all electrical equipment. Remove the ignition key.
Open the bonnet Link.
Press on the arrow Fig. 1 and take off the cover -1-.
Lift the cap -2- at the positive terminal.
Follow the correct procedure for connecting the charger cables to the jump-start terminals (terminal with cap = "positive", terminal with hexagon = "negative").
Now connect the battery charger to the mains and switch on.
After charging the battery: switch off the battery charger and disconnect the mains cable.
Now disconnect the charger cables.
Refit the cap -2- onto the positive terminal and fit the cover -1-.
Close the bonnet Link.
When it is discharged the battery can freeze at temperatures around 0°C. You must not use a battery which has frozen, even after it has thawed, because the ice may have cracked the battery casing and allowed the battery acid to escape WARNING!.
Charging the battery
Only use battery chargers with a maximum charge voltage of 14.8 V (the battery cables do not have to be disconnected). The battery must not be opened while you are charging it.
Important: Before you charge the battery make sure you read the manufacturer's instructions for using the battery charger.
Note
Use only the terminals in the engine compartment to charge the battery.