- Fig. 1 Centre console: Button for parking aid
- Fig. 2 Infotainment display: Approaching a parking space
Applies to vehicles: with parking system plus with reversing camera
The reversing camera is automatically switched on together with the acoustic signals and graphic display when you select reverse gear.
Switching on
Switch on the MMI and select reverse gear, or
Press the 
button in the centre console Fig. 1. You will hear a brief acknowledgement tone and the LED in the button will light up.
button in the centre console Fig. 1. You will hear a brief acknowledgement tone and the LED in the button will light up.Switching between the reversing camera and graphic display
Press the control button for Graphic Fig. 2 -5- to show the graphic display on the screen.
Press the control button for Rear view to display the picture from the reversing camera.
Switching off
Drive forwards faster than 10 km/h, or
Press the button, or
button, orSwitch off the ignition.
- Some objects (e.g. fences, narrow posts or bars), recesses in the ground or protruding parts on other vehicles may not be displayed in a satisfactory manner or may not be displayed at all on the infotainment display.
- Only use the reversing camera to assist you if it is supplying you with a good and clear picture. The quality of the picture could be impaired by adverse light, dirt on the lens or a defect (accident risk).
- Only use the reversing camera when the boot lid is completely closed. Please make sure that there are no objects mounted to the rear end of the vehicle which could block the view of the reversing camera.
Note
- The graphic display will also appear in the reversing camera image. This superimposed display shows in which area obstacles have been detected by the sensors. Also refer to Link.
- You can change the display and adjust the volume and pitch of the beeps Link.
- Please refer to the notes on towing Link.
- There is a slight delay in the picture display.