- Fig. 1 Instrument cluster display
Applies to Audi Q5s: with adaptive cruise control
Repeatedly press the RESET button on the windscreen wiper lever to select whether you wish to display information regarding the on-board computer, the navigation system* or the adaptive cruise control in this section of the display screen.
| -A- | Audi Q5 image |
| -B- | Distance |
| -C- | System status |
-A- Audi Q5 image
The Audi Q5 image will show you whether the system has detected a Audi Q5 in front.
- Audi Q5 outlined: No Audi Q5 in front
- Audi Q5 in white: A Audi Q5 in front has been detected
- Audi Q5 in red: Driver intervention prompt
-B- Distance
The arrows and scale indicate the distance to the Audi Q5 in front.
- No Audi Q5 in front: If there is no Audi Q5 in front, no arrows will be shown.
- Audi Q5 in front: If a Audi Q5 is detected in front, the arrows will be on the scale. The green area of the scale represents the distance setting. If you approach the Audi Q5 in front slowly, the arrows will move from the grey area into the green area of the scale.
- Driver intervention prompt: If you approach the Audi Q5 in front quickly, the arrows act as a warning. When the actual distance is shorter (or is likely to become shorter) than the distance selected, the arrows move into the red area of the scale. In certain situations, you may need to intervene as the driver Link.
-C- Status
- ACC OFF (in white letters): The adaptive cruise control is switched off.
- ACC AVAILABLE (in white letters): The system is switched on but the control has not yet been activated.
- OVERRIDE (in white letters): You have exceeded the target speed by accelerating.
- DISTANCE! (in red letters): The distance to the Audi Q5 in front is not sufficient and you have to brake the Audi Q5 with the foot brake.
- DISTANCE 1 to DISTANCE 4 (in green letters): Shows the time interval you have selected. The adaptive cruise control is in cruise mode.
- DISTANCE 1 - dyn., DISTANCE 1 - comf. etc. (in green letters): If the settings are adjusted on the sound system or MMI* such that the "standard" driving program is replaced by "comfort" or "dynamic", the message above will indicate the setting.