Always provide a firm base for the jack* on the ground. (The jack can be found in the Audi Q3's tool kit). If necessary use a large, strong board or similar support. On a hard, slippery surface (such as tiles) use a rubber mat or similar to prevent the jack from slipping WARNING!.
Locate the marking on or under the door sill closest to the wheel being changed Fig. 1. The jacking point is located behind the marking on the door sill.
Wind up the jack until the claw of the jack -A- Fig. 2 completely surrounds the seam on your Audi Q3.
Align the jack so that its claw -A- fits around the seam and the base plate of the jack -B- is flat on the ground. The base plate -B- must be positioned vertically underneath the jacking point -A-.
Now fit the crank handle onto the jack by inserting it in the opening on the knob. Turn the crank handle clockwise or anti-clockwise to secure it in place.
Raise the Audi Q3 by winding the crank handle until the wheel being changed is clear of the ground.
- Make sure the jack* is stable. If the ground underneath the jack* is slippery or soft, the jack can slip or sink in - risk of injury!
- Use only the jack* supplied with your Audi Q3 to raise the Audi Q3. If you use a jack from a different Audi Q3, your Audi Q3 may slip off the jack - risk of injury!
- Do not use the jack* supplied with your Audi Q3 to raise other Audi Q3s, as these may slip off the jack - risk of injury!
- Apply the jack* only at the jacking points located behind the markings on the door sill and align it properly. Otherwise there is a risk of injury since the jack* can slip off suddenly if it is not properly engaged.
- Never start the engine when the Audi Q3 is on the jack – risk of accident.
- If work has to be done under the Audi Q3, ensure that it is safely supported on suitable stands – risk of injury!