- Fig. 1 Display: Approaching a parking space
- Fig. 2 Display: Aligning the vehicle
- Fig. 3 -1-: Area covered by the reversing camera; -2-: area NOT covered by the reversing camera
Applies to vehicles: with parking system plus with reversing camera
Parking mode 1 can be used when parking your vehicle in a garage or parking bay.
Switch on the MMI and select reverse gear.
Turn the steering wheel until the orange orientation lines -1- are pointing towards the parking space Fig. 1. You can estimate the distance to an obstacle by referring to the markings -2-. Each marking is equivalent to 1 metre. The blue marking is an extension of the vehicle outline and reaches about five metres to the rear of the vehicle.
- The reversing camera does not show the complete area behind the vehicle Fig. 3. It is particularly important to ensure that there are no small children or animals near the vehicle, as the reversing camera may not always be able to detect them (accident risk).
- Please note that objects which are not touching the ground may appear to be further away than they actually are (e.g. the bumper of a parked vehicle, a towing bracket or the rear end of a truck). In this case you should not use the orientation lines as a guide when parking the car - accident risk!
The MMI display shows the path of the rear end of the vehicle if you were to reverse using the current steering angle. NB: The front end of the vehicle swings out further than the rear. Please make sure you keep a sufficient distance between the vehicle and any obstacles to make sure that the exterior mirror or edge of the vehicle do not collide with the obstacle (accident risk).