-
- Fig. 1 Turn signal and main beam lever: Switching main beam assist on/off
Applies to vehicles: with main beam assist
The main beam assist automatically switches the main beam headlights
on or off depending on the surrounding light conditions.
Controls
Important: The dipped beam headlights must be on, the light
switch must be set to AUTO and the automatic dip function must
be activated on the MMI
Link.
Push the lever to position -1- to activate the main beam assist.
The indicator lamp
will light
up in the instrument cluster display and the main beams will
be switched on and off automatically. The indicator lamp
tells
you when the main beams are on.
will light
up in the instrument cluster display and the main beams will
be switched on and off automatically. The indicator lamp
tells
you when the main beams are on.
When the main beam assist is activated and the main beams have
been switched on automatically, you can dip the headlights manually
by pulling the lever to position -2-.
You can switch the main beams on manually if they are not activated
automatically when you need them. To do so, push the lever to
position -1-. The indicator lamp
will
light up. To dip the headlights again, pull the lever to position
-2-.
will
light up. To dip the headlights again, pull the lever to position
-2-.
In both of the above cases, you can activate the main beam assist
again by pushing the lever to position -1-.
Pull the lever to position -2- to flash the headlights when
the main beam assist is activated. The main beam assist will
remain activated.
Driver messages in the instrument cluster display
main beam assist: system fault
Drive to a qualified workshop soon and have the fault rectified.
You can still switch the main beam headlights on and off manually.
main beam assist: please clean windscreen
The camera vision is impaired, e.g. by stickers or dirt.
The sensor is located between the interior mirror and the windscreen.
Do not affix any stickers on this section of the windscreen.
WARNING!
The main beam assist is only intended to assist the driver. The
driver must always ensure that the headlights are used when required,
and may have to switch them on or off manually, e.g. when the light
conditions or visibility are poor. In the following situations manual
intervention may be necessary:
- Hazardous weather conditions such as fog, heavy rain and snow or water splashes.
- Roads on which oncoming traffic is partially concealed (e.g. on motorways).
- Indiscernible road users (e.g. cyclists with poor lighting)
- Tight corners, steep hill crests or valleys
- Poorly lit towns
- Highly reflective objects, such as road signs
- Windscreen misted up, dirty, frosted or covered by stickers in front of the sensor
Note
The main beam assist is deactivated whenever you intervene by switching
the main beams on or off manually
Fig. 1 -1-/-2-.