-
- Fig. 1 Mobile phone bonded to on-board phone system
Applies to vehicles: with phone pre-installation
Important: Available mobile phones must be shown on the MMI display
Link, and the vehicle must be stationary.
Turn the rotary pushbutton to select a mobile phone and press the
rotary pushbutton.
To bond the mobile phone, turn the rotary pushbutton to
Handsfree and press the rotary pushbutton.
A 4-digit PIN code will appear on the MMI display.
To enter the 4-digit PIN code shown in the display, select
Yes. Enter this PIN code on the mobile
phone. You will be given about 30 seconds to complete the entry,
or
To enter any 4 to 16-digit PIN code, select
No. Enter any 4 to 16-digit PIN code
via the speller
Link. Then also enter this PIN code on the mobile phone. You
will be given about 30 seconds to complete the entry.
Confirm the bonding process on the mobile phone when prompted to
do so. The Bluetooth symbol -1-
Fig. 1 will
appear in the status line of the MMI display when the mobile phone
has been bonded successfully.
After the mobile phone has been bonded, the contacts are automatically
loaded into the directory of the MMI. It may take several minutes
to load the entries, depending on how many contacts are stored on
the mobile phone. For more information about the directory, please
refer to
Link.
Note
- You have to enter the PIN code once only. Any Bluetooth devices that have already been bonded to the MMI system once are connected automatically when they are within range. Please pay attention to any connection queries on your mobile phone.
- For more information on how to bond your mobile phone, please refer to the mobile phone operating instructions.
- For up-to-date information on the phone pre-installation, please see the Internet (e.g. www.audi.com/bluetooth) or contact an Audi dealer.