-
- Fig. 1 Engine compartment: Terminals for jump leads and battery charger
-
- Fig. 2 Jump-starting with the battery of another vehicle: -A- – Boosting battery, -B- – Discharged battery
The two jump leads must be connected in the correct sequence.
The jump-start terminals are located in the engine compartment
Fig. 1.
Connecting the positive terminals with the positive lead (red)
Open the red cap on the positive terminal
Fig. 1.
Connect one end of the positive lead (red) to the
jump-start terminal
Fig. 2 -1-
(terminal under red cap = "positive") of the vehicle with the
flat battery -B-.
Connect the other end of the positive lead (red) to the positive
terminal -2- of the boosting battery -A-.
Connecting the negative terminals with the negative lead (black)
Connect one end of the negative lead (black) to the negative
terminal -3- of the boosting battery -A-.
Connect the other end of the negative lead (black) to the
jump-start terminal -4-
(terminal with hexagon = "negative") of the vehicle with the
flat battery -B-.
Starting the engine
Start the engine of the vehicle with the boosting battery -A-
and let it run at idling speed.
Now start the engine of the vehicle with the discharged battery
-B-.
If the engine fails to start: do not operate the starter for
longer than 10 seconds. Wait for about 30 seconds and try again.
When the engine is running, disconnect the leads in exactly
the opposite sequence to
that described above.
Refit the red cap onto the positive terminal.
The battery is vented to the outside to prevent gases entering the
vehicle's interior.
Connect the battery clamps so they have good
metal-to-metal contact with the
respective terminals.
WARNING!
- The non-insulated parts of the battery clamps must not be allowed to touch. The jump lead attached to the positive battery terminal must not touch metal parts of the vehicle: this can cause short circuiting.
- Do not bend over the batteries - risk of acid burns.
- The screw plugs on the battery cells must be screwed in firmly.
- Keep sparks, flame and lighted cigarettes away from batteries: the gases given off can cause an explosion.
- If jump-starting another vehicle, position the jump leads in such a way that they cannot come into contact with any moving parts in the engine compartment of the other vehicle.
Caution!
Please note that the above method of connecting the leads is meant
for jump-starting your vehicle. If jump-starting another vehicle,
you should not connect the negative lead
(–) to the negative terminal
of the discharged battery, but directly to the engine block or a
solid metal part bolted to the engine block. If the battery of the
other vehicle does not have a gas vent, there is a risk that a mixture
of oxygen and hydrogen gas can accumulate and cause an explosion.