-
- Fig. 1 Turn signal and main beam lever: Switching adaptive headlight range control on/off
Applies to vehicles: with adaptive headlight range control
The adaptive headlight range control automatically regulates the
cone of light emitted by the main beam headlights depending on the
ambient surroundings.
A camera (located in the mounting for the interior mirror) detects
light sources from other road users. The vertical and horizontal
range of the headlights is varied smoothly and steplessly between
dipped and main beams. The system controls the activation/deactivation
of the main beams depending on how far away the traffic is on either
side of the road.
Controls
Important: The dipped beam headlights must be on, the light
switch must be set to AUTO and the automatic dip function must
be activated on the MMI
Link.
Push the lever to position -1- to activate the adaptive headlight
range control. The indicator lamp 
will light up in the instrument cluster display and the main
beams will be activated/deactivated automatically. If the indicator
lamp
lights
up, the main beams are partially or fully on.
will light up in the instrument cluster display and the main
beams will be activated/deactivated automatically. If the indicator
lamp
lights
up, the main beams are partially or fully on.
When the adaptive headlight range control is activated and the
main beams have been switched on automatically, you can dip
the headlights manually by pulling the lever to position -2-.
You can switch the main beams on manually if they are not activated
automatically when you need them. To do so, push the lever to
position -1-. The indicator lamp
will
light up. To dip the headlights again, pull the lever to position
-2-.
will
light up. To dip the headlights again, pull the lever to position
-2-.
In both of the above cases, you can activate the adaptive headlight
range control again by pushing the lever to position -1-.
Pull the lever to position -2- to flash the headlights when
the adaptive headlight range control is activated. The adaptive
headlight range control remains activated.
Do not affix any stickers to the windscreen in the vicinity of the
camera.
Driver message in the instrument cluster display
Main beam assist: system fault
Drive to a qualified workshop soon and have the fault rectified.
You can still switch the main beam headlights on and off manually.
Main beam assist: please clean windscreen
The camera vision is impaired, e.g. by stickers or dirt.
The sensor is located between the interior mirror and the windscreen.
Do not affix any stickers on this section of the windscreen.
WARNING!
The adaptive headlight range control is only intended to assist
the driver. The driver must always ensure that the headlights are
used when required, and may have to switch them on or off manually,
e.g. when the light conditions or visibility are poor. In the following
situations manual intervention may be necessary:
- Hazardous weather conditions such as fog, heavy rain and snow or water splashes.
- Roads on which oncoming traffic is partially concealed (e.g. on motorways).
- Indiscernible road users (e.g. cyclists with poor lighting)
- Tight corners, steep hill crests or valleys
- Poorly lit towns
- Highly reflective objects, such as road signs
- Windscreen misted up, dirty, frosted or covered by stickers in front of the sensor
Note
The range of the headlight beams will be adjusted automatically
when traffic in front is detected on either side of the road. This
prevents you from dazzling other road users.