The automatic mode maintains a constant temperature inside the vehicle. Air temperature, output and distribution are regulated automatically.

You can set separate temperatures for the driver's and front passenger's sides using controls -1- and -3-.

You can adjust the blower speed manually using control -2-. You should leave the blower on at a low setting to prevent the windows from misting up and to ensure that the vehicle interior is constantly ventilated. Press the AUTO button for automatic control of the blower speed.

You can direct the flow of air manually to selected outlets. Press the AUTO button for automatic air distribution.

In air recirculation mode, the air from the interior of the vehicle is filtered and recirculated. This setting prevents fumes etc. from entering the interior. We recommend switching on the air recirculation mode when driving through a tunnel or in traffic queues WARNING!.

The air recirculation mode is switched off when the AUTO or FRONT button is pressed.

The OFF button is used to switch the air conditioner on and off. The air conditioner will also switch on if you press the blower control. When the air conditioner is switched off, the supply of air from outside the car is cut off.

When the air cooling is switched off, the air is neither cooled nor dehumidified. The windows may mist up as a result. The air cooling is switched off automatically at low outside temperatures.

The windscreen and side windows are defrosted or demisted as quickly as possible. The air output is increased to maximum and most of the air comes out of the outlets below the windscreen. The air recirculation mode is deactivated. The temperature should be set to approx. 22 °C.

The defroster is switched off when the AUTO button is pressed.

The rear window heating operates only when the engine is running and switches off automatically after a few minutes, depending on the outside temperature.

To switch on the rear window heating permanently, press and hold the REAR button for at least two seconds. It will then remain on until the ignition is switched off.

When you press the button, the seat heating is switched on at level 3 (the highest level). The LEDs indicate the temperature level. To reduce the temperature, press the button again. To switch off the seat heating, press the button repeatedly until all the LEDs have gone out.

The seat heating automatically switches from level 3 to level 2 after 10 minutes.

The thumbwheels can be used to open and close the air outlets in the centre and on either side of the dashboard and rear centre console. The lever in the centre of the outlets can be used to adjust the direction of air flow.