- Fig. 1 Turn signal lever: Button for active lane assist
- Fig. 2 Windscreen: Camera window for active lane assist
Applies to vehicles: with Audi active lane assist
Press the button Fig. 1 to switch the system on/off. The indicator lamp or in the instrument cluster will light up or go out.
Indicator lamps
Ready: The indicator lamp lights up when the system is fully functional. The system is ready to intervene.
Not ready: The indicator lamp lights up when the system is switched on but not ready to intervene. The causes for this can include the following:
- There is no lane marking or only one.
- The system cannot detect the relevant lane markings (e.g. temporary markings for road works or markings obscured by snow, dirt, rain or adverse light).
- The vehicle's speed is below 65 km/h, the speed at which the lane assist system is activated (the threshold may vary in different export markets).
- The lane is narrower than 2.5 m or wider than 5 m.
- The bend is too tight.
- You have taken your hands off the steering wheel.