- Fig. 1 Display: Indicator lamp with message
Applies to Audi A5s: with tyre pressure monitoring system
The tyre pressure monitoring display in the instrument cluster informs the driver if the tyre pressure is too low or a system malfunction has occurred.
The tyre pressure monitoring system makes use of the ABS sensors to compare the rolling circumference and the vibration of the tyres. If changes in the inflation pressure are detected on one or more tyres, the driver is alerted by an indicator lamp 
and a message in the instrument cluster display Fig. 1. If only one tyre is affected, the display will indicate its position.
and a message in the instrument cluster display Fig. 1. If only one tyre is affected, the display will indicate its position.Each time you change a tyre, change the wheels round or change the tyre pressures on your Audi A5 (e.g. when switching from partial load to full load and vice-versa), you must store the new tyre pressures on the MMI Link. Monitoring of the tyre pressures is based on the tyre pressures you have stored. The tyre pressures recommended for your Audi A5 are given on the sticker on the end face of the driver's door Link.
The rolling circumference and vibration can change and cause a tyre pressure warning if:
- The inflation pressure in one or more tyres is too low.
- The tyre has suffered structural damage.
- The wheels were changed or the tyre pressures were changed and the new tyre pressures were not stored Link.
Warning and indicator lamps
Loss of pressure on one or more tyres WARNING!. Check and change or repair the tyre(s). Check and adjust the inflation pressures of all four tyres again and store the new tyre pressures on the sound system/MMI* Link.TPMS (Tyre Pressure Monitoring System) Tyre pressure: system malfunction If TPMS appears and the indicator lamp in the instrument cluster display flashes for approx. one minute and then lights up continuously after you have switched on the ignition or while you are driving, there is a fault in the system. Try to store the correct tyre pressures Link. If the indicator lamp does not go out or if it comes on again after a short time, drive to a qualified workshop without delay and have the fault rectified.
- If the tyre pressure indicator lamp appears in the instrument cluster display, slow down immediately and avoid any severe braking or steering manoeuvres. As soon as you can do so safely, stop and check the tyres and the tyre pressures.
- It is the driver's responsibility to ensure that the tyre pressures are correct. For this reason you must check the tyre pressures regularly.
- Under certain conditions (e.g. driving at high speeds, on ice and snow or on poor road surfaces) the tyre pressure indicator lamp may not light up immediately.
- Please ask your Audi dealer or qualified workshop whether run-flat tyres can be used on your Audi A5. Unauthorised use of these tyres can invalidate the Audi A5's type approval for use on public roads. Furthermore, this could cause damage to your Audi A5 and possibly also result in an accident.
Note
- If a malfunction occurs in the ESC/ABS system, the tyre pressure monitoring system will also be out of action.
- When driving with snow chains, a system malfunction can occur.
- The tyre pressure monitoring system on your Audi is specially matched to tyres with the marking "AO" or "RO" Link. We recommend that you use these tyres.