|
It is best to have all servicing of wheels and tyres performed by a qualified workshop, since they have the necessary special tools and replacement parts in addition to trained personnel.
New tyres do not yet give maximum grip. When driving with new tyres, drive at moderate speeds and be especially careful during the first 500 km.
All four wheels must be fitted with tyres of the same type, size (rolling circumference) and preferably the same tread pattern.
(Applies to RS model: ) All four wheels must be fitted with tyres of the same type, size (rolling circumference) and tread pattern.
Tyres should be replaced in pairs and not individually (i.e. both front tyres or both rear tyres together).
We recommend the use of Audi Genuine Tyres. If you wish to use other tyres, please note that the actual size can differ from the nominal size marked on the tyre ►.
If you wish to purchase a different combination of rims and tyres than the ones fitted on the vehicle during production, it is advisable to consult a qualified workshop beforehand ►.
The sizes of the rims and tyres approved for your vehicle are listed in the vehicle s documents (e.g. EC Certificate of Conformity or COC document 1)). The vehicle documents vary depending on the country in which the vehicle is registered.
If the spare wheel* is not the same type as the tyres fitted on the car (for example if the car has winter tyres or wide-section tyres) you should only use the spare wheel* if a puncture occurs, and then only for a short period of time. In this case, please drive with extra care. Refit a normal road wheel as soon as possible.
(Applies to vehicles with four-wheel drive: ) All four wheels must always be fitted with tyres of the same type, make and tread pattern, as the driveline could otherwise be damaged by variations in the wheel speeds. For the same reason, only use a spare wheel* which has the same rolling circumference as the normal road wheels.
Manufacturing date
The manufacturing date is indicated on the tyre sidewall (possibly only on the inner side of the wheel):
DOT ... 2217 ...
means, for example, that the tyre was produced in the 22nd week of 2017.
Audi Genuine Tyres
Audi Genuine Tyres with the marking “AO” are specially matched to your Audi. When used properly, these tyres meet the highest standards in safety and handling. Your specialist retailer will be glad to provide more information.
- Do not use steel wheels which are 17 inches or larger. Otherwise damage to the vehicle and an accident could result.
- Use only tyre/rim combinations and matching wheel bolts approved by Audi. Otherwise damage to the vehicle and an accident could result.
- For technical reasons, it is not possible to use wheels from other vehicles. In certain cases, it is not even possible to use wheels from another vehicle of the same model.
- It is very important to ensure that the tyres you have chosen have adequate clearance. When selecting replacement tyres, do not rely entirely on the nominal tyre size marked on the tyre; with some makes of tyre the effective tyre size can differ significantly from the nominal dimensions, even though the tyres have the same size designation. Inadequate tyre clearance can result in damage to the tyres or the vehicle, causing a serious safety risk.
- Avoid running the car on tyres that are more than 6 years old. If you have no alternative, you should drive slowly and with extra care at all times.
- The use of run-flat tyres on your vehicle is NOT authorised! Unauthorised use can cause an accident or damage your vehicle.
- If wheel trims are fitted after the car is purchased, ensure that there is an adequate flow of air for cooling the brakes – risk of accident!