|
Applies to: vehicles with telephone
Select: MENU button > Telephone > right control button > Telephone settings.
Call forward: Forwarding of incoming calls to your mailbox or to another phone number can be switched on/off. You can use Check status to check whether this function is activated or deactivated.
Call waiting: If this option is activated 
, you will be informed of incoming calls when you are on the phone. You can use Check status to check whether this function is activated or deactivated.
, you will be informed of incoming calls when you are on the phone. You can use Check status to check whether this function is activated or deactivated.
Transmit caller ID: Sending your telephone number in outgoing calls can be activated/deactivated. With the Network-dependent option, the setting agreed in your mobile network service contract will be used. The settings apply only to the Telephone menu in the MMI system. When the Bluetooth connection has been terminated, the settings of your mobile phone apply. You can use Check status to check whether this function is activated or deactivated.
On vehicles with a car telephone kit, you can choose between three different telephone modes to optimise the mobile network response:
- Automatic: The car telephone automatically switches between the GSM (2G), UMTS (3G) and LTE networks. This depends on the mobile network s availability and reception, and on the position of the vehicle. There may be restrictions when using the satellite map*1) or Wi-Fi.
- Telephony optimised: The car telephone kit registers with the GSM network (2G). In this mode, the reception is prioritised for making and receiving calls. There may be restrictions when using the satellite map*1) or Wi-Fi.
- Data service optimised: The car telephone registers with the GSM (2G), UMTS (3G) or LTE network. This depends on the mobile network, its reception, and the position of the vehicle. In this mode, the reception is prioritised for the use of data services. There may be restrictions when making and receiving calls.
You can use the Mute telephone function to switch ring tone playback via the MMI loudspeakers on/off. Ring tones are played when you select the function Ring tone. Select an entry from the list and confirm it. For the settings Ring tone volume/Message volume, see link►. You can adjust the Microphone input level during an active phone call using the rotary pushbutton.
Network settings*
Refer to link►.
The serial number of the telephone module installed in the MMI system is displayed.
Applies to: vehicles with car telephone kit
The car telephone will be turned “on” automatically when the ignition is switched on, as long as it was not switched off separately the last time it was used.
Note
- You can bond several mobile phones to the MMI system; however only two* connections are active at a time.
- All bonded Bluetooth devices can be deleted by resetting the Bluetooth function to the factory settings link►.
- If you select the telephone mode* Automatic or Telephony optimised, there may be network restrictions if you try to use Audi connect infotainment services* and make telephone calls at the same time.