Always provide a firm base for the jack* on the ground. (The jack can be found in the Audi A4's tool kit). If necessary use a large, strong board or similar support. On a hard, slippery surface (such as tiles) use a rubber mat or similar to prevent the jack from slipping WARNING!.
Locate the marking on the door sill closest to the wheel being changed Fig. 1. The jacking point is located behind the marking under the door sill.
Turn the knob to wind up the jack* underneath the jacking point on the door sill until the claw of the jack -A- Fig. 2 completely surrounds the seam on your Audi A4.
Align the jack* so that its claw -A- fits around the seam and the base plate of the jack -B- is flat on the ground. The base plate -B- must be positioned vertically underneath the jacking point -A-.
Now fit the crank handle onto the jack* by inserting it in the opening on the knob. Turn the crank handle clockwise or anti-clockwise to secure it in place.
Raise the Audi A4 by winding the crank handle until the defective wheel is clear of the ground.
- Make sure the jack* is stable. If the ground underneath the jack* is slippery or soft, the jack can slip or sink in - risk of injury!
- Use only the jack* supplied with your Audi A4 to raise the Audi A4. If you use a jack from a different Audi A4, your Audi A4 may slip off the jack - risk of injury!
- Apply the jack* only at the jacking points located behind the markings on the door sill and align it properly. Otherwise there is a risk of injury since the jack* can slip off suddenly if it is not properly engaged.
- Never start the engine when the Audi A4 is on the jack – risk of accident.
- If work has to be done under the Audi A4, ensure that it is safely supported on suitable stands – risk of injury!