|
Applies to vehicles: with telephone
Requirements
The vehicle must be stationary, and the ignition must be switched on.
The Bluetooth function and the discoverability option of the MMI system ►Link and the mobile phone must be activated.
The MMI and the mobile phone you would like to bond must not be connected actively to any other Bluetooth device.
Connecting a mobile phone
Select the TEL button > Connect mobile phone > Find new devices. The available Bluetooth devices are shown on the MMI display. Or: Search for the MMI system via the Bluetooth device search function on your mobile phone.
Select and confirm the desired mobile phone from the list of Bluetooth devices shown.
Select and confirm Handsfree. The MMI will generate a PIN for the connection Fig. 2.
Select and confirm Yes.
Enter the PIN to establish a connection on your mobile phone. Or: If the PIN is already being displayed on your mobile phone, confirm it on the phone and in the MMI. You have about 30 seconds to enter the PIN.
Please note any additional system queries on your mobile phone, e.g. whether the phone should connect automatically in the future. On some mobile phones, you may also need to download the directory separately.
After connecting successfully
The signal strength bar -9- Fig. 3 and the Bluetooth symbol -14- will appear in the status line of the MMI display when the mobile phone has been connected successfully. In addition, the contacts on the mobile phone are automatically loaded into the directory of the MMI. This may take several minutes, depending on how many contacts are stored on the mobile phone.
If there is no memory capacity left for directories and you connect another mobile phone, a message will appear asking you to replace the contacts from one of the phones. If you select the option Restricted use of telephone, only the contacts from the mobile phone and the local MMI memory (public) will be available ►Link.
Note
- Making and receiving telephone calls via the MMI is only possible using the Bluetooth connection (Handsfree).
- Bluetooth devices only have to be bonded once. Any devices that have already been bonded to the MMI system are connected automatically when they are within range and the ignition is on.
- You can speed up the automatic connection by authorising the MMI connection on your mobile phone.
- You can bond several mobile phones to the MMI system; however only one connection is active at a time.
- Any Bluetooth device that is already actively connected to the MMI system is disconnected when another device is connected to the system.
- The Bluetooth connection between the system and the mobile phone is automatically terminated when you leave the car.
- For further information regarding your mobile phone, contact your mobile network service provider or refer to the operating instructions for your mobile phone. For information on using a phone in your car, please go online (e.g. www.audi.com/bluetooth) or ask an Audi dealer.