|
Applies to: vehicles with Audi active lane assist
- Fig. 162 Turn signal lever: Button for active lane assist
- Fig. 163 Windscreen: Camera window for active lane assist
Press the button Fig. 162► to switch the system on/off. The indicator lamp in the instrument cluster will light up or go out.
Analogue instrument cluster | Audi virtual cockpit* | Meaning on corresponding side |
Green lines
 |
Green line(s)
(left/right) |
The active lane assist is switched on and ready to warn. |
- | Red line
(left/right)  |
The active lane assist warns you before you cross the lane demarcation. In addition, the steering wheel vibrates slightly. |
Yellow lines
 |
Grey line(s) (left/right)  | The active lane assist is switched on but not ready to warn. |
The system may be switched on but not ready to warn due to the following reasons:
- There are no lane markings.
- The system cannot detect the relevant lane markings (e.g. temporary markings for road works or markings obscured by snow, dirt, rain or adverse light).
- The vehicle s speed is below 65 km/h, the speed at which the lane assist system is activated (the threshold may vary in different export markets).
- The traffic lane is too narrow or too wide.
- The bend is too tight.
- You have taken your hands off the steering wheel.