|
Applies to: vehicles with neck heating
The neck heating works when the engine is running.
- Fig. 87 Driver s seat: Air outlets for neck heating
- Fig. 88 Dashboard: Neck heating
The neck heating has three levels. When you press the button 
Fig. 88►, the neck heating is switched on at level 3 (the highest level). The LEDs indicate the ventilation level. To reduce the ventilation, press the button again. To switch off the neck heating, press the button repeatedly until all the LEDs have gone out.
Fig. 88►, the neck heating is switched on at level 3 (the highest level). The LEDs indicate the ventilation level. To reduce the ventilation, press the button again. To switch off the neck heating, press the button repeatedly until all the LEDs have gone out.
The neck heating automatically switches from level 3 to level 2 after about 6 minutes when the soft top is closed.
WARNING
- People with limited capacity to feel pain or sense temperature could burn themselves when using the neck heating. These people must not use the neck heating – risk of injury!
- If the air outlets in the seat Fig. 87► are covered by items of clothing or similar while the neck heating is on, the air that emerges immediately afterwards can be very hot. This could cause burns to bare skin in the immediate vicinity of the air outlets.
Note
- The blower output is always lower when the soft top is closed than when it is open.
- The power management system link► may reduce the temperature in certain situations if the vehicle battery voltage is too low.