|
Applies to: vehicles with convenience key
You can use the
START ENGINE STOP button to switch on the ignition and start the engine.
-
- Fig. 101 Centre console: START ENGINE STOP button
Plug-in hybrid drive*:
Please also note the information on starting the vehicle link►
.
Starting the engine
(Manual gearbox:) Press the clutch pedal all the way down and move the gear lever into neutral.
(Automatic gearbox: ) Press the brake pedal and move the selector lever to position P or N.
Press the
START ENGINE STOP button briefly to start the engine.
Applies to: vehicles with diesel engine
The engine may take a few seconds longer than usual to start on cold days. Please keep your foot on the clutch pedal (manual gearbox) or brake pedal (automatic gearbox) until the engine starts. The indicator lamp
lights up while the glow plugs are preheating.
lights up while the glow plugs are preheating.Electrical components with a high power consumption are switched off temporarily while you start the engine.
If the engine fails to start immediately, switch off the starter by pressing the
START ENGINE STOP button once more and try again after about 30 seconds.
Switching the ignition on/off
If you only wish to switch on the ignition and do not want to start the engine as well, proceed as follows:
Press the
START ENGINE STOP button without pressing the clutch (manual gearbox) or brake pedal (automatic gearbox). Vehicles without start/stop system*:
The rev counter needle will move to the
READY position.
To switch off the ignition, press the button again. The rev counter needle will move to the
OFF position.
Diesel engines are automatically preheated when you switch on the ignition.
If the indicator lamp
flashes and the message
Please move steering wheel appears when you switch on the ignition, the steering wheel is locked. In this case, turn the steering wheel slightly to the left/right.
flashes and the message
Please move steering wheel appears when you switch on the ignition, the steering wheel is locked. In this case, turn the steering wheel slightly to the left/right.
Start/stop system*
Please note the information on link►
.
CAUTION
Avoid high engine speeds, full throttle and extreme load conditions until the engine has reached its normal operating temperature; otherwise this can damage the engine.
For the sake of the environment
Do not warm up the engine by running it with the car stationary. You should drive off immediately whenever possible. This will help avoid unnecessary exhaust emissions.
Note
- Any noises which may be heard when the engine is started are quite normal and no cause for concern.
- If you leave your vehicle with the ignition switched on, it will be switched off automatically after a while. Please note that electrical equipment such as the exterior lighting will also be switched off.