|
- Fig. 1 Charging system: Operating unit
Applies to Audi A3s: with plug-in hybrid drive
The operating unit automatically detects the voltage and the available amp rating. In the settings you can specify whether you want to charge at half or full capacity.
Press the OK button -D- Fig. 1 on the operating unit.
Enter the PIN if necessary.
POWER and SET PIN will appear on the display.
Select POWER using the arrow buttons -C-.
Press the OK button -D-.
The charging current display will appear. The current setting (50 % or 100 %) is surrounded by a frame.
Use the up or down arrow buttons -C- if you want to change the setting.
Press the OK button -D-.
Note
- The charging capacity is automatically set to 100 % if you are using a domestic power outlet. The charging capacity can be limited to 50 % to prevent the electrical installation from overheating.
- The charging capacity is automatically set to 50 % if you are using an industrial power outlet. The 100 % setting must be selected for the battery to be charged at full capacity.
- The selected value remains stored until the mains plug is connected again.