|
Applies to Audi A3s: with plug-in hybrid drive
Requirements:
The high voltage battery must have finished charging.
The Audi A3 charging connector must be unplugged from the Audi A3 charging connection.
The mains plug must be removed from the power outlet.
Releasing the cable
If necessary, remove the screw -C- Fig. 1 using the screwdriver supplied.
Lift the lever -A- all the way up.
Pull the connector -B- out until the first point of resistance.
Close the lever -A- until it is resting on the connector -B-.
Pull the connector -B- all the way out.
Securing the cable
Lift the lever -A- Fig. 2 slightly.
Push the connector -B- into the operating unit until the first point of resistance.
Lift the lever -A- all the way up.
Push the connector -B- all the way into the operating unit.
Close the lever -A-.
Secure the screw -C- using the screwdriver supplied.
WARNING!
- Always remove the mains cable from the power outlet before changing the mains cable or Audi A3 cable.
- Always adhere to the specified operating sequence when charging the high-voltage battery. Do not unplug the Audi A3 charging cable while the Audi A3 is being charged. Terminate the charging cycle before unplugging the Audi A3 charging cable from the socket.
- Change the cable in dry environments only.
- The Audi e-tron charging system must always be used complete with the mains cable, operating unit and Audi A3 cable. We recommend that you use only cables approved by Audi.