It is best to have all servicing of wheels and tyres performed by a
qualified workshop, since they have the necessary special tools and
replacement parts and trained personnel.
New tyres do not yet give maximum grip. When driving with new tyres,
drive at moderate speeds and be especially careful during the first
500 km.
All four wheels must be fitted with tyres of the same type, size (rolling
circumference) and preferably the same tread pattern.
Tyres should be replaced in pairs and not individually (i.e. both front
tyres or both rear tyres together).
We recommend the use of Audi Genuine Tyres. If you wish to use other
tyres, please note that the actual size can differ from the nominal
size marked on the tyre
WARNING!.
If you wish to purchase a different combination of rims and tyres than
the ones fitted on the vehicle during production, it is advisable to
consult a qualified workshop beforehand
WARNING!.
If the spare wheel*
is not the same type
as the tyres fitted on the car (for example if the car has winter tyres
or wide-section tyres) you should only use the spare wheel*
if a puncture occurs, and then only for a short period of time. In this
case, please drive with extra care. Refit a normal road wheel as soon
as possible.
On vehicles with four-wheel drive,
all four wheels must always be fitted with tyres of the same type, make
and tread pattern, as the driveline could otherwise be damaged by variations
in the wheel speeds. For the same reason, only use a spare wheel*
which has the same rolling circumference as the normal road wheels.
Manufacturing date
The manufacturing date is indicated on the tyre sidewall (possibly
only on the inner side of the wheel):
DOT ... 2214 ...
means, for example, that the tyre was produced in the 22nd week
of 2014.
Audi Genuine Tyres
Audi Genuine Tyres with the marking "AO" or "RO" are specially matched
to your Audi. When used properly, these tyres meet the highest standards
in safety and handling. Your specialist retailer will be glad to
provide more information.
- Use only tyre/rim combinations and matching wheel bolts approved by Audi. Otherwise damage to the vehicle and an accident could result.
- For technical reasons, it is not possible to use wheels from other vehicles. In certain cases, it is not even possible to use wheels from another vehicle of the same model.
- It is very important to ensure that the tyres you have chosen have adequate clearance. When selecting replacement tyres, do not rely entirely on the nominal tyre size marked on the tyre; with some makes of tyre the effective tyre size can differ significantly from the nominal dimensions, even though the tyres have the same size designation. Inadequate tyre clearance can result in damage to the tyres or the vehicle, causing a serious safety risk.
- Avoid running the car on tyres that are more than 6 years old. If you have no alternative, you should drive slowly and with extra care at all times.
- Run-flat tyres* may only be used on vehicles which were originally equipped with this type of tyre Link.
- If wheel trims are fitted after the car is purchased, ensure that there is an adequate flow of air for cooling the brakes – risk of accident!