New brake pads
New brake pads do not give full braking effect for the first 400 km,
they must first be "bedded in". However, you can compensate for
the slightly reduced braking effect by applying more pressure on
the brake pedal. Avoid placing a heavy load on the brakes during
the running-in period.
Wear
The rate of wear on the brake pads
depends a great deal on how you drive and the conditions in which
the vehicle is operated. Negative factors are, for instance, city
traffic, frequent short trips or hard driving with abrupt starts
and stops.
Noises
Brake noise may develop in certain situations, depending on the
speed, braking force and ambient conditions (such as temperature
and relative humidity).
Effect of moisture or salt
In certain conditions, such as in heavy rain, early morning dew,
or after washing the car or driving through water, the full braking
effect can be delayed by moisture (or in winter by ice) on the discs
and brake pads. The brakes should be "dried" by pressing the pedal
to restore full braking effect.
When you are driving at higher speeds with the windscreen wipers
on, the brake pads are very briefly brought into contact with the
brake discs. This automatic process which goes unnoticed by the
driver is carried out at regular intervals and is intended to improve
braking response in wet conditions.
The effectiveness of the brakes can also be temporarily reduced
if the car is driven for some distance without using the brakes
when there is a lot of salt on the road in winter. The layer of
salt that accumulates on the discs and pads can be removed with
a few cautious brake applications.
Corrosion
There may be a tendency for dirt to build up on the brake pads and
corrosion to form on the discs if the car is used infrequently,
or if you only drive low mileages without using the brakes very
much.
If the brakes are not used frequently, or if corrosion has formed
on the discs, it is advisable to clean off the pads and discs by
braking firmly a few times from a moderately high speed
WARNING!.
Faults in the brake system
If the brake pedal travel should ever increase
suddenly, this may mean that
one of the two brake circuits has failed. Drive immediately to the
nearest qualified workshop and have the fault rectified. On the
way to the dealer, be prepared to use more pressure on the brake
pedal and allow for longer stopping distances.
Low brake fluid level
Malfunctions can occur in the brake system if the brake fluid level
is too low. The brake fluid level is monitored electronically.
Brake servo
The brake servo amplifies the pressure you apply to the brake pedal.
It only works when the engine is running.
- When applying the brakes to clean off deposits on the pads and discs, select a clear, dry road. Be sure not to inconvenience or endanger other road users; do not risk an accident.
- Never let the car coast with the engine switched off (this can cause accidents).
Caution!
- Never let the brakes "drag" by leaving your foot on the pedal when you do not really intend to brake. This overheats the brakes, resulting in longer stopping distances and greater wear.
- Before driving down a long, steep gradient, it is advisable to reduce speed and select a lower gear. In this way you will make use of the engine braking effect and relieve the load on the brakes. If you still have to use the brakes, it is better to brake firmly at intervals than to apply the brakes continuously.
Note
- If the brake servo is out of action, you must apply considerably more pressure to the brake pedal than you normally would.
- If you wish to equip the car with accessories such as a front spoiler or wheel covers, it is important that the flow of air to the front wheels is not obstructed, otherwise the brakes can overheat.