- Fig. 1 Rear light with retainer already installed
- Fig. 2 Boot lid: Location of the retaining screw for the rear light
Fit the retainer and tighten the nut slightly Fig. 1.
Plug in the electrical connector.
Insert the rear light.
Open the boot lid.
Tighten the nuts hand-tight in the correct order (-1- to -4-) using the box spanner.
To use the screwdriver as a handle for turning, insert it through the hole on the side of the box spanner and then carefully tighten the nuts in the correct order (-1- to -4-).
Fit the three covers.
Make sure that all bulbs for the rear lights are working.
Put the screwdriver and box spanner back into the tool kit.